JVC HR-J458E VCR User Manual


 
EN 23
SET TAPE SPEED (J458E ONLY)
4
Press SP/LP ( ) to set the tape speed.
SET VPS/PDC MODE
5
Press VPS/PDC to select "ON" or "OFF".
If "VPS/PDC ON" is displayed on the screen or "VPS/
PDC" is lit on the display panel, VPS/PDC is set to ON.
If "VPS/PDC OFF" is displayed on the screen or "VPS/PDC"
is not lit on the display panel, VPS/PDC is set to OFF.
"VPS/PDC Recording" on page 25.
RETURN TO NORMAL SCREEN
6
Press PROG or OK. "PROGRAM COMPLETED" appears
on the screen for about 5 seconds, then normal screen
appears.
Repeat steps 16 for each additional programme.
ENGAGE RECORDER’S TIMER MODE
7
Press . The recorder turns off automatically and
appears on the display panel.
To disengage the timer, press again.
NOTES:
To Change The Stop Time . . .
. . . press STOP +/– after pressing OK in step 3. You can
compensate for anticipated programme schedule delays this
way.
To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing OK in step 3, press WEEKLY (NUMBER key
“9”) for weekly serials or DAILY (NUMBER key “8”) for daily
serials (Monday – Friday). Either "WEEKLY" or "DAILY"
appears on the screen. Pressing the button again makes the
corresponding indication disappear.
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on screen and "FULL"
appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes (
pg. 26).
It is not possible to timer-record a TV programme with a
S
HOW
V
IEW
number which starts with "0".
ATTENTION
Regarding Guide Program Number Set
"GUIDE PROG SET" appears after performing step 3 if the
Guide Program number for the SHOWVIEW number you
entered has not been set.
Press the NUMBER keys or %fi to input the channel
position number on which your recorder receives that
station, then press OK or . The SHOWVIEW program
screen appears.
GUIDE PROG SET
GUIDE PROG TV PROG
2 – –
[5∞] =
[PROG] : EXIT
(Ex.) To timer-record a ZDF
programme with SHOWVIEW.
* If your recorder receives
ZDF on the channel
position 2, press OK or
after entering "2".
Satellite Tuner Users
To timer-record a satellite broadcast using SHOWVIEW:
1 Set "AV2 SELECT" to "AV2" ( pg. 31).
2 Perform steps 17.
3 Set the satellite tuner to the appropriate channel before
the selected programme begins.
4 Leave the satellite tuner's power on.
%
%
123
456
7
89
0
2
4
1
3
?
SP/LP
WEEKLY
DAILY
VPS/PDC
PROG
OK
STOP+/–