Filter
Top Products
16 EN
q
¢
¢
1
¡
PLAYBACK (cont.)
Next Function Memory
You can set your recorder's power to go off automatically after
the tape is fully rewound. Before starting, make sure the
recorder is in the Stop mode.
For Automatic Power Off After Tape Rewind . . .
. . . press REW, then press within 2 seconds.
NOTE:
If you want the power to be turned off automatically when the
counter reads “0:00:00” (instead of at the beginning of the
tape), press C.MEMORY so that the “M” mark appears before
pressing REW.
Counter Memory
Returns to the counter reading of “0:00:00” to conveniently find
a specific place on the tape automatically.
SET COUNTER MEMORY
1
Press C. (COUNTER) RESET during playback at a point
you wish to locate later. The counter reads “0:00:00”.
Then press C.MEMORY, and “M” appears in front of the
counter digits.
ACTIVATE COUNTER
MEMORY
2
When you wish to return to the designated point, press
STOP and then REW or FF.
● The tape rewinds or fast-forwards and stops at about
0:00:00 automatically.
● To cancel Counter Memory, press C.MEMORY again.
FF
REW
COUNTER RESET
STOP
¶
1
4¢
7
3
8
¡
123
456
7
/
8
0
9
4
2
1
3
FF
REW
C.MEMORY
STOP
C. RESET
AUDIO MONITOR
Soundtrack Selection (HR-J648E/EH only)
Your video recorder is capable of recording three soundtracks (HI-FI L, HI-FI R and NORM) and will play back the one you select.
During Playback
Pressing AUDIO MONITOR on the remote control changes the soundtrack being played back as follows:
NOTES:
●
"L + R" should normally be selected. In this mode, Hi-Fi stereo
tapes are played back in stereo, and the normal audio track is
played back automatically for tapes with only normal audio.
●
For instructions on recording stereo and bilingual
programmes, refer to page 22.
●
"O.S.D." must be set to "ON" or the on-screen displays will
not appear (
੬
pg. 20).
TRACK
USE
(On-Screen Display)
HI FI
For Hi-Fi stereo tapes
LR
HI FI
For main audio of Bilingual tapes
L
HI FI
For sub audio of Bilingual tapes
R
NORM For audio-dubbed tapes
HI FI
For audio-dubbed tapes
NORM