Filter
Top Products
Filename [HRJ680EU2.fm]
Masterpage:Right
EN
25
D
Set the tape speed.
Press
SP/LP
(
p
).
E
Set the VPS/PDC mode.
Press
VPS/PDC
to select “ON” or “OFF”.
● If “VPS/PDC ON” is displayed on the TV screen, VPS/PDC is
set to ON.
● If “VPS/PDC OFF” is displayed on the TV screen, VPS/PDC is
set to OFF.
੬
“VPS/PDC Recording” on page 27.
F
Return to the normal screen.
Press
PROG
or
OK
. “PROGRAM COMPLETED” appears
on the TV screen for about 5 seconds, then the normal
screen appears. If “PROGRAM OVERLAPPED” appears
on the TV screen, see page 29.
● Repeat steps
1
–
6
for each additional programme.
G
Engage the recorder’s timer mode.
Press
#
(
TIMER
). The recorder turns off automatically and
#
appears on the front display panel.
● To disengage the timer mode, press #
(
TIMER
) again.
NOTES:
● To Change The Stop Time . . .
. . . press
STOP
+/–
after pressing
OK
in step
3
. You can
compensate for anticipated programme schedule delays.
● To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing
OK
in step
3
, press
WEEKLY
(
NUMBER
key
“
9
”) for weekly serials or
DAILY
(
NUMBER
key “
8
”) for daily
serials (Monday — Friday). Either “WEEKLY” or “DAILY”
appears on the TV screen. Pressing the button again makes the
corresponding indication disappear.
● You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, “PROGRAM FULL” appears on the TV screen. To record
the extra programme, you must first cancel any unnecessary
programmes (
੬
pg. 28).
● It is not possible to timer-record a TV programme with a
S
HOW
V
IEW
number which starts with “0”.
● It is not possible to timer-record a satellite broadcast received
on the channel position “0” by the satellite receiver.
Satellite Receiver Users
To timer-record a satellite broadcast using the S
HOW
V
IEW
system:
A Perform “Satellite Receiver Control Setting” on page 13.
B Perform steps
1
–
7
. In step
5
, you cannot set “VPS/PDC”
to “ON”.
C Leave the satellite receiver’s power on.
ATTENTION
Guide Program Number Set
“GUIDE PROG SET” appears after performing step
3
if the
Guide Program number for the S
HOW
V
IEW
number you
entered has not been set.
If you want to set the Guide Program number for the satellite
broadcast station, press the
NUMBER
key “
0
” to change “TV
PROG” to “SAT”. Press
rt
to input the channel position
number on which your recorder or satellite receiver receives
that station, then press
OK
or
e
to set the Guide Program
number. The S
HOW
V
IEW
Program screen appears.
(Example)
To timer-record a ZDF
programme with the
S
HOW
V
IEW
system.
* If your recorder receives ZDF on
the channel position 2, press
OK
or
e
after entering “2”.
HRJ680EU2.fm Page 25 Tuesday, November 21, 2000 12:32 PM