JVC HR-J682EU VCR User Manual


 
Filename [HRJ680EU3.fm]
Masterpage:Right
EN
39
* The default setting is
bold
in the table below.
8
L-2 SELECT
A/V
: To use this recorder as the recording
deck with the player connected to
the AV2 (L-2) IN/DECODER
connector, or to use the satellite
receiver connected to the AV2 (L-2)
IN/DECODER connector.
DECODER
: To use a decoder connected to the
AV2 (L-2) IN/DECODER connector.
SAT
: To view a satellite programme with
the TV set while the recorder is
turned off. (
pg. 33)
Set this function to the appropriate mode depending on the
type of unit connected to the rear panel AV2 (L-2) IN/
DECODER connector of the recorder.
NOTES:
If you have a decoder connected to the AV2 (L-2) IN/DECODER
connector, be sure to set “L-2 SELECT” back to “DECODER”
after editing.
If you’re not connecting a decoder to the AV2 (L-2) IN/
DECODER connector, leave “L-2 SELECT” set to “A/V”.
The default setting is “A/V”; if the recorder’s memory backup has
expired due to a power cut or because the AC was removed
from the recorder, “A/V” will be automatically selected when
the power is restored to the recorder. If you are using a decoder,
be sure to set “L-2 SELECT” back to “DECODER”.
When “L-2 SELECT” is set to “SAT”, “SAT” or “SAt” appears on
the screen or front display panel instead of “L-2”.
8
COLOUR SYSTEM
PAL/NTSC
: To record PAL signals, or play back a
PAL or NTSC tape.
MESECAM
: To record SECAM signals, or play
back a MESECAM tape.
You can play back PAL, NTSC and MESECAM tapes, or
record PAL and SECAM* signals on this recorder. Select the
appropriate colour system.
* SECAM signals will be recorded as MESECAM on this recorder;
MESECAM is the designation for tapes with SECAM signals that
have been recorded on a MESECAM-compatible PAL video
cassette recorder.
NOTES:
About NTSC Playback
Some TVs shrink the picture vertically and place black bars at
the top and bottom of the TV screen. This is not a malfunction
on the part of either the video recorder or the TV.
The picture may roll up and down. This can be corrected using
the V-HOLD control found on some TVs. (This cannot be
corrected if the TV does not have a V-HOLD control.)
The counter and tape remaining time readings will be incorrect.
During search, still, or frame-by-frame playback, the picture will
be distorted, and there may be a loss of colour.
Depending on the type of TV, the top and bottom portions of
superimposed displays may be cut off during NTSC playback.
HRJ680EU3.fm Page 39 Friday, November 17, 2000 11:46 AM