Filter
Top Products
24 EN
EDITING
Edit To Or
From Another
Video
Recorder
You can use your video recorder as the source player or the
recording deck.
MAKE CONNECTIONS
1
Connect the player’s AUDIO/VIDEO OUT connector to
the recorder’s AUDIO/VIDEO IN connector.
● Use the L connector for monaural connection.
SET RECORDING DECK’S
INPUT MODE
2
Set to AUX. With this video recorder, press NUMBER
key "0" and/or TV PROG to select depending on the
connector being used — “AU” for the rear panel
VIDEO/AUDIO input connectors, or “F-AU” for the
front panel VIDEO/AUDIO input connectors.
START SOURCE PLAYER
3
Engage its Play mode.
START RECORDING DECK
4
Engage its Record mode.
NOTES:
●
All necessary cables can be obtained from your dealer.
●
NTSC tapes being played back in the NTSC
[
PAL mode
(
੬
p. 27) cannot be dubbed to another recorder.
●
When you dub an NTSC tape using your recorder as the
playback deck, select NTSC 3.58 (or NTSC 4.43) with the
COLOUR SYSTEM button. (
੬
p. 26)
Another recorder
Recorder Player
Another recorder
RF Cable (provided)
VIDEO
CHANNEL
Your recorderPlayerTV Receiver Recorder Your recorder TV Receiver
RF Cable
(provided)
VIDEO
CHANNEL
¶
1
4¢
7
3
8
¡
123
456
7
8
0
9
2
4
1
3
NUMBER "0"
TV PROG
IMPORTANT:
● To edit, both the player and the recorder must be of the
same colour system. Press your recorder's COLOUR
SYSTEM button to select the appropriate colour system.
● For more information on multi-system compatibility,
੬ pg. 26.
AV Cable
(not provided)
AV Cable
(not provided)