Filter
Top Products
36
SUBSIDIARY SETTINGS (cont.)
SELECT STATION NAME
CHARACTER
1
Press
#
until the first letter
of the station name begins
blinking.
ENTER NEW CHARACTER
2
Press
%fi
to cycle through the characters (A–Z, 0–9, –,
*
, +, (space) ) and stop when the desired character
is indicated, then press
#
to enter. Enter the remaining
characters the same way (maximum of 4).
After entering all characters, press OK.
●
The Confirmation screen appears.
●
If you make a mistake, press
@
until the incorrect
character begins blinking. Then enter the correct
character by pressing
%fi
.
CLOSE CONFIRMATION
SCREEN
3
Press MENU.
Set Stations (B)
Perform steps 1 and 2 of "Storing Channels Manually" on page
34 to access the Confirmation screen before continuing.
SELECT ITEM
1
Press
%fi
@ #
until the item you want to set begins
blinking.
ACCESS MANUAL
CHANNEL SET SCREEN
2
Press OK twice.
SELECT NEW STATION
3
Press
#
until the station
name (ID) begins blinking,
then press
%fi
until the
new station’s name (ID)
you want to store begins
blinking.
Registered station names
(
☞
pg. 37) appear as you
press
%fi
.
SWITCH STATIONS
4
Press OK.
●
The Confirmation screen appears.
●
Repeat steps 1 through 4 as necessary.
CLOSE CONFIRMATION
SCREEN
5
Press MENU.
Set Stations (A)
Set station names that are registered in your recorder.
Perform steps 1 and 2 of "Storing Channels Manually" on page
34 to access the Confirmation screen and then perform step 1
and 2 of "Set Stations (A)" on the left before continuing.
Set station names other than the ones registered in your
recorder.
PR CH ID FINE
06 CH45 –––– +/–
[5∞] : CHANGE ID
[
] : CURSOR +=
: OK
[MENU] : EXIT
∞
∞
PR CH ID FINE
06 CH45 BBC1 +/–
[5∞] : A-Z, 0-9
[
] : CURSOR +=
: OK
[MENU] : EXIT
∞
∞