JVC HR-J870EU VCR User Manual


 
Masterpage:Right-NoTitle0
EN
27
Filename [HRJ870EU2.fm]
Page 27 July 12, 2000 3:32 pm
D
Set the tape speed.
Press
SP/LP/EP
(
p
).
It is not possible to select EP mode if “COLOUR SYSTEM” is
set to “MESECAM”
. (
pg. 59
)
E
Set the VPS/PDC mode.
Press
VPS/PDC
to select “ON” or “OFF”.
If “VPS/PDC ON” is displayed on the TV screen or “VPS/PDC”
is lit on the front display panel, VPS/PDC is set to ON.
If “VPS/PDC OFF” is displayed on the TV screen or “VPS/PDC”
is not lit on the front display panel, VPS/PDC is set to OFF.
“VPS/PDC Recording” on page 29.
F
Return to the normal screen.
Press
PROG
or
OK
. “PROGRAM COMPLETED” appears
on the TV screen for about 5 seconds, then the normal
screen appears. If “PROGRAM OVERLAPPED” appears
on the TV screen and “Err” on the front display panel, see
page 31.
Repeat steps
1
6
for each additional programme.
G
Engage the recorder’s timer mode.
Press
#
(
TIMER
). The recorder turns off automatically
and “
#
” appears on the front display panel.
To disengage the timer mode, press
# (
TIMER
) again.
NOTES:
To Change The Stop Time . . .
. . . press STOP +/– in step 3. You can compensate for
anticipated programme schedule delays.
To Timer-Record Weekly Or Daily Serials . . .
. . . in step 3, press WEEKLY (number key9”) for weekly
serials or DAILY (number key8”) for daily serials (Monday —
Friday). Either “WEEKLY” or “DAILY” appears on the TV
screen. Pressing the button again makes the corresponding
indication disappear.
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, “PROGRAM FULL” appears on the TV screen and
“FULL” appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes (
pg. 30).
It is not possible to timer-record a TV programme with a
S
HOW
V
IEW
number which starts with “0”.
Satellite Receiver Users
To timer-record a satellite broadcast using the S
HOW
V
IEW
system:
A Perform “Satellite Receiver Control Setting” on page 15.
B Perform steps
1
7
. In step
3
, the front display panel
shows “L2” for the channel position. In step
5
, you cannot
set “VPS/PDC” to “ON”.
C Leave the satellite receiver’s power on.
ATTENTION
Guide Program Number Set
“GUIDE PROG SET” appears after performing step
3
if the
Guide Program number for the S
HOW
V
IEW
number you
entered has not been set.
If you want to set the Guide Program number for the satellite
broadcast station, press the
number key
0
” to change “TV
PROG” to “SAT”. Press
rt to input the channel position
number on which your recorder or satellite receiver receives
that station, then press
OK
or
e to set the Guide Program
number. The S
HOW
V
IEW
Program screen appears.
(Example)
To timer-record a ZDF
programme with the
S
HOW
V
IEW
system.
* If your recorder receives ZDF on
the channel position 2, press OK
or
e
after entering “2”.
HRJ870EU2.fm Page 27 Wednesday, July 12, 2000 3:32 PM