JVC HR-S5900AM VCR User Manual


 
EN 29
ACCESS TITLE EDIT SCREEN
5
Press the NUMBER key
“1”. The Title Edit screen
appears.
You can access the Title
Edit screen only when
“PROG. NAVIGATION”
is set to “ON”. (pg.
38)
ENTER PROGRAMME TITLE
6
Press the NUMBER keys
and PUSH JOG
#
to enter
characters, then press OK
For details, refer to
“Entering Character” on
page 41.
RETURN TO NORMAL
SCREEN
7
Press PROG or OK. "PROGRAM COMPLETED" appears
on the screen for about 5 seconds, then normal screen
appears. If “PROGRAM OVERLAPPED” appears on the
screen and “Err” on the display panel, see page 35.
Repeat steps 17 for each additional programme.
ENGAGE RECORDER'S
TIMER MODE
8
Press
. The recorder turns off automatically and "
"
appears on the display panel.
To disengage the timer, press
again.
NOTES:
To Change The Stop Time . . .
. . . press STOP +/– after pressing OK in step 3. You can
compensate for anticipated programme schedule delays this
way.
To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing OK in step 3, press WEEKLY (NUMBER key
"9") for weekly serials or DAILY (NUMBER key "8") for daily
serials (Monday – Friday). Either "WEEKLY" or "DAILY"
appears on the screen. Pressing the button again makes the
corresponding indication disappear.
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on screen. To record the
extra programme, you must first cancel any unnecessary
programmes (
pg. 34).
It is not possible to timer-record a TV programme with a
G-
CODE
number which starts with "0".
In case of a power failure after programming, the recorder's
memory backup keeps your selections (if the lithium battery is
not exhausted).
ATTENTION
Regarding Guide Program Number Set
"G-CODE/SHOWVIEW SETUP" appears after performing
step 3 if the Guide Program number for the G-
CODE number
you entered has not been set.
Press the NUMBER keys or PUSH JOG %fi to input the
channel position number on which your recorder
receives that station, then press OK or PUSH JOG .
The G-
CODE program screen appears.
(Ex.) To timer-record a RTR
programme with the G-
CODE
system.
* If your recorder receives
RTR on the channel position
2, press OK or PUSH JOG
after entering "2".
%
%
WEEKLY
DAILY
OK
STOP+/
PUSH JOG
NUMBER
G-CODE/SHOWVIEW SETUP
GUIDE PROG TV PROG
2–
[0-9] OR [
5
/
]:SELECT =
[PROG] : EXIT
Satellite Tuner Users
To timer-record a satellite broadcast using the G-CODE
system:
Perform steps 18.
Set the satellite tuner to the appropriate channel before
the selected programme begins.
Leave the satellite tuner's power on.
PROG
– P1 –
25.04 21:00 PR.1
[0–9] : SELECT LETTERS
[
] : DELETE
[
2
/
3
] : CURSOR+=
: OK [PROG] : EXIT
– P1 –
25.04 W
7
[0–9] : SELECT LETTERS
[
] : DELETE
[
2
/
3
] : CURSOR+=
: OK [PROG] : EXIT
HR-S5900/5990AM-EN26-46 5/9/02, 4:31 PM29