Filter
Top Products
42 EN
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control's A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
SET REMOTE CONTROL
CODE FOR REMOTE
CONTROL
1
Press and hold VCR.
Press the NUMBER key “2”.
Press OK, and release VCR.
● The remote control now can transmit B code control
signals.
CHECK REMOTE CONTROL
CODE FOR RECORDER
2
Press and hold PLAY on the recorder for more than
5 seconds while the recorder is turned off. The code
currently set appears on the display panel.
CHANGE CODE FOR
RECORDER
3
Press any key on the remote control. The recorder now
responds to B code control signals.
To control two recorders with the
same remote control
You can control two JVC recorders by switching the remote
control code for the remote control between A and B (੬ step
1), keeping two recorders to different control codes.
● To change only the remote control code for the remote
control, DO NOT perform steps 2 and 3.
NOTE:
To set the recorder back to respond to A code signals, repeat the
same procedure as shown above except pressing NUMBER key
"1" instead of "2" in step of 1.
SPECIAL FEATURES
Remote
Control
Functions
NUMBER "2"
VCR
NUMBER "1"
OK
PLAY
HR-S5900/5990AM-EN26-46 5/9/02, 4:32 PM42