Filter
Top Products
basic features 25
– –:– –
AUDIO
0000
VPS/PDC
3
5
3
2 4
30 SEC
?
PR
PR
PR
ENTER
LP00000-000
VCR/TV
i
0000
ENTER
i
3
PR
PR
set pdc mode Press PDC (number key 7) to change between ON and OFF.
Programme Delivery Control (
PDC) is a service designed to ensure that timer
recording still works in the event of a change in time of broadcast. If you set
PDC
to ON, your VCR will be turned on not by its own timer but by a signal
transmitted by the broadcaster. This means that if an advertised programme is
delayed, your VCR will still record it properly.
satellite receiver users To timer-record a satellite broadcast using Express
Timer Programming:
• You cannot set
PDC to ON.
• You cannot timer-record the satellite broadcast received on the channel
position ‘0’ by the satellite receiver.
• Leave the satellite receiver’s power on.
For memory capacity and Serial Recording, see
VIDEO Plus+ Timer Programming
on page22.
Return to Normal Screen
Press p or . PROGRAM COMPLETED appears on the TV screen for
about 5 seconds, then the normal TV screen appears. (੬ pg. 27)
Engage Timer Mode
You must now put the VCR into Timer Mode by pressing c otherwise no
recording will take place. c will appear on the display panel. To disengage the
Timer Mode, press c again.
If a video tape with the safety tab removed is loaded, c, Play indicator (,) and
Record indicator (U) will flash. Insert another tape with the safety tab in place to
record!
If no video tape is loaded, c indicator will flash. Insert a tape to record!
If the tape reaches its end during timer recording, the recording stops and “c”,
“U” and “,” on the display panel blink. Press c to disengage timer, then press
S/0 on the VCR to eject the tape or press othen press < to rewind the
tape.
HR-S6965EK-EN/p21-28 2/19/03, 07:55 PM25