Filter
Top Products
42
?
– –:– –
12
3
4
65
7
8
9
0
2
4
1
3
FF
REW
STOP
PAUSE
PLAY
ADVANCED OPERATIONS (cont.)
Auto SP
→
LP Timer
If, when timer-recording in SP mode, there is not enough tape to
record the entire programme, the recorder automatically
switches to LP mode to allow complete recording.
For Example . . .
Recording a programme of 210 minutes in length onto a 180-
minute tape
NOTES:
●
The Auto SP
→
LP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will not work
properly with any tapes longer than E-180 or with some tapes
of shorter lengths.
●
If you have programmed the recorder to timer-record 2 or more
programmes, the second programme and those thereafter may
not fit on the tape if you set "AUTO SP
→
LP TIMER" to "ON". In
this case, make sure the mode is not engaged, then set the tape
speed manually during timer programming.
●
In order to ensure that the recording fits on the tape, this
feature may leave a short non-recorded section at the end of
the tape.
●
There may be some picture noise and sound disturbance at
the point on the tape where the recorder switches from SP to
LP mode.
●
If you perform timer recording with both PDC and the Auto
SP
→
LP Timer activated, and the programme goes beyond its
originally scheduled length, there may be times when the
programme cannot be recorded in its entirety.
Total 210 minutes
Approximately 150 minutes Approximately 60 minutes
SP mode LP mode
Make sure you set "AUTO SP→LP TIMER" to "ON" at the Mode
Set screen before the timer-recording starts.
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS MODE SET
SCREEN
2
Press %fi to move the highlight bar (pointer) to "MODE
SET", then press OK or
#
.
SELECT MODE
3
Press %fi to move the
highlight bar (pointer) to
"AUTO SP→LP TIMER",
then press OK or
#
to select
"ON".
RETURN TO NORMAL
SCREEN
4
Press MENU.
MODE SET
B. E. S. T. ON
PICTURE CONTROL AUTO
AUTO TIMER OFF
O. S. D. ON
DIRECT REC ON
AUTO SP=LP TIMER ON
DIGITAL 3R ON
NEXT PAGE
[5∞] =
[MENU] : EXIT
OK
MENU