Filter
Top Products
Masterpage:Right-Full-NoTitle0
EN
61
Filename [HRS8850EU4.fm]
Page 61 April 17, 2001 5:01 pm
* The default setting is
bold
in the table below.
8
DIGITAL 3R
ON
OFF
When this function is set to “ON”, the Digital 3R picture
system applies edge correction to the luminance signal to
enhance detail.
NOTES:
●
Normally it is recommended to keep “DIGITAL 3R” set to
“ON”.
●
Depending on the type of tape being used, picture quality may
be better with “DIGITAL 3R” set to “OFF”.
●
If you use the recorder as the source player for editing, be sure
to set “DIGITAL 3R” to “OFF” before starting.
8
POWER SAVE
ON
OFF
When this function is set to “ON”, you can reduce the
power consumption while the recorder is turned off.
NOTES:
●
During Power Save mode ...
... the front display panel will be turned off.
... the Just Clock function (
੬
pg. 70) does not work.
... the picture may be distorted momentarily when you turn on/
off the recorder.
●
Power Save does not work when ...
... the recorder is in the Timer mode.
... the recorder’s power is turned off after timer-recording or
Instant Timer Recording.
... the Automatic Satellite Programme Recording mode is
engaged (
੬
pg. 37).
... “L-2 SELECT” is set to “DECODER” or “SAT” (
੬
pg. 47).
8
VIDEO STABILIZER
ON
OFF
When this function is set to “ON”, you can automatically
correct vertical vibration in the picture when playing back
unstable recordings made on another recorder.
NOTES:
●
When you finish viewing a tape, be sure to set this function to
“OFF”.
●
Regardless of the setting, this function has no effect during
recording and during special effects playback.
●
The on-screen display may jitter vertically when this function is
set to “ON”.
●
To watch recordings with close-caption, set this function to
“OFF”.
●
Video Stabilizer and Digital TBC/NR cannot be used at the same
time. If you activate Digital TBC/NR when “VIDEO STABILIZER”
is set to “ON”, Video Stabilizer will be automatically turned
“OFF”.
HRS8850EU4.fm Page 61 Tuesday, April 17, 2001 5:02 PM