Filter
Top Products
April 20, 2004 9:28 am Page 8
— 8 —
Master Page: Right
Playing back tape repeatedly (100 times)
— Repeat Playback
During playback, press and hold 4 for more than 5 seconds. “$”
on the display panel starts blinking slowly. To stop playback, press
8 on the remote control or 0 on the recorder.
NOTE:
Pressing 4, 3, 5 or 9 also stops Repeat Playback.
Locating beginning of recordings
— Index Search
Index codes are placed on the tape at the
beginning of each recording when
recording on this recorder.
A
While the tape is not running, press w or
e (2 or 6) to start search.
B
To access a recording of 2 to 9 index
codes away, press w or e (2 or 6)
repeatedly until the correct number is displayed on the screen
(only if “O.S.D.” is set to “ON” (
੬
12)).
Example:
To locate the beginning of B from
the current position, press w
twice.
To locate the beginning of D from
the current position, press e
once.
● Playback begins automatically
when the desired recording is
located.
Locating beginning of timer recordings
— Instant Review
After ensuring that the recorder is turned off and that the timer
mode is disengaged, press REVIEW.
● The recorder turns on, and rewinds to the index code indicating
the beginning of the last timer-recorded programme, then begins
playback automatically.
● You can access a programme as far as
9 index codes away from the current tape
position.
● The Instant Review function can also
operate if the recorder is turned on.
Skipping unwanted portions
— Skip Search
Press 30 SEC once to 4 times during playback. Each press
initiates a 30-second period of high-speed playback (up to
2 minutes). When the specified portion of the tape is skipped,
normal playback resumes automatically. To return to normal
playback during Skip Search, press 4.
Accidental erasure prevention
To prevent accidental recording on a
recorded cassette, remove its record
safety tab. To record on it later, cover
the hole with adhesive tape.
Basic Recording
A
Load a cassette
Make sure the record safety tab is intact. If not, cover the hole with
adhesive tape before inserting the cassette.
● The recorder turns on, and the counter is reset, automatically.
B
Select recording channel
Press PR r/t or the number keys on the remote control or PR+/–
on the recorder.
● You can select channel in the stop mode or recording pause mode.
C
Start recording
On the recorder, press 7. Or on the remote control, while holding
7, press 4.
NOTE:
If the tape reaches its end during recording, the recording stops
and “ ⅜” and “ $” on the display panel blink. Press 0 on the
recorder to eject the cassette or press 3 to rewind the tape.
Current position
Index numbe
r
Recording
Turn on the TV and select the video channel or AV mode.
During recording
Pause recording
Press 9.
● Press 4 to resume recording.
● You can select channel in the recording pause mode.
Stop recording
Press 8 on the remote
control.
OR Press 0 on the recorder.
Record safety tab
HR-V210_001EN.fm Page 8 Tuesday, April 20, 2004 9:28 AM