Filter
Top Products
basic features 29
Notes on Recording
When using both the RF and SCART cables, you can switch between TV and
VCR by pressing the
TV/VCR button on the Remote Control.
Display Tape Position/Time Counter
Press the OK button repeatedly to display the tape position and time counter
on the TV screen. To reset the time counter, press 0000.
NOTES:
• Set OSD to ON to display the indications on the TV screen. (੬ pg. 43)
• Depending on the type of tape used, the tape position may not appear right
away.
Change Display Information
By pressing the OK button repeatedly, you can change the TV screen between
the clock time and the tape position/time counter.
Resetting the Counter
Press the OK button so that the counter display appears on the TV screen.
While the display is shown, press the
0000 button. You can reset the counter to
‘0:00:00’ before starting playback or recording.
Record a Programme While Watching Another
If your VCR is connected to the TV with both the RF cable and 21-pin SCART
cable, press
TV/VCR.
Once you have started recording all you need to do is use the controls on your
TV set to tune to a different programme. The programme set using the
PR
button on the Remote Control is the one which will be recorded.
HR-V505EK-EN/p23-30 2/12/03, 6:33 PM29