Filter
Top Products
EN
41
This Remote is capable of transmitting two control
codes; one set to respond to A code control signals and
another set to respond to B code control signals.
This Remote control is preset to send A code signals
because your VCR is initially set to respond to A code
signals. You can easily modify your VCR and the Remote
to respond to B code signals.
When using two JVC VCRs, set two VCRs and their
Remotes to different codes, so that you can operate these
VCRs separately.
1
Unplug VCR
Unplug the AC power cord from the AC outlet.
2
Set remote control code for Remote
1 Press and hold A/B.
2 Press the Number key “2”.
3 Press OK, and release A/B.
● The Remote now can transmit B code control
signals.
3
Plug in VCR
Plug the AC power cord back into an AC outlet.
4
Turn on VCR
Press POWER on the Remote.
● The VCR now responds to B code control
signals.
● To set the Remote and the VCR back to A code
control signals, repeat the same procedure as
shown above except pressing the Number key
“1” in step 2.
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote
control code for the Remote between A and B (੬ step
2), keeping two VCRs to different control codes.
● Press the Number key “1” for A code control signals
and the Number key “2” for B code control signals. (To
change only the remote control code for the Remote,
DO NOT perform steps 1, 3, and 4 .)
Changing
Remote Control
Code
(Ex.) To set Remote to B code:
MBRSET
A/B
2
OK
3
E
N
T
E
R
/
O
S
D
Press in succession
Hold
down
Release
123
456
7
89
0
2
4
1
3
2 –2, 3
2 –1
4
2
–3