Filter
Top Products
8
Remote A/B/C/D Code Switching
The remote control is capable of controlling four JVC
video units independently. Each of units can respond to
one of four codes (A, B, C or D). The remote control is
preset to send A code signals because your unit is ini-
tially set to respond to A code signals. You can easily
modify your unit to respond to B, C or D code signals.
On the remote control
Keep pressing VCR down during steps 1 – 2.
11
Change the remote control code.
Press the number key “1” for A, “2” for B, “3” for C
or “4” for D.
22
Set the remote control code.
Press OK to set the code.
On the unit
3
Turn off the unit.
Press .
44
Display the code.
Press PLAY on the unit for over 5 seconds while
the unit is turned off. The code currently set appears
on the front display panel.
If the code displayed on the front display panel is
different from the code set on the remote control, go
to step 5.
55
Change the unit’s code.
Press
ÁÁ
on the remote control. The code currently set
on the remote control will be applied to the unit.
Note
Once you have set the remote control to operate the TV,
you do not have to repeat this step until you replace your
remote control’s batteries or until you pull out the power
cord.
I
Before performing the following steps:
Slide the TV/VCR/DVD switch to the right.
VCR DVD
POWER
DVD MENU MEMORY
SUBTITLE ANGLE
REPEAT A-B ZOOM
SEARCH
TITLE
REPEAT
SHOWVIEW
VIDEO Plus+
TV
TV
TV/VCR
TV/VCR PR +
CANCEL
TV/VCR PR
0000
A
U
D
IO
M
O
N
IT
O
R
PRO
G
.
TV
123
456
7
0
89
R
A
N
D
O
M
DISPLAY
EJECT
RETURN
OK
AUX
TV
1
1 - 2
2
5
3
4