JVC HR-XVC11B DVD VCR Combo User Manual


 
7
Introduction
The DVD deck is selected.
A disc is in the DVD deck.
(Lights when a disc is in the DVD deck
and Flashes when no disc.)
Indicates when the Progressive scan is active.
Indicates repeat mode.
The unit is in timer recording or a timer recording
is programmed (VCR part only).
This indicator will flash when the unit is set to
standby mode for Timer-Link recording.
A cassette is in the VCR deck.
The VCR deck is selected.
The unit is Recording. (VCR part only)
Indicates PM time. (AM is not displayed.)
Indicates total playing time, elapsed time,
remaining time or current deck status
(Playback, Pause, etc).
PM
REC
VCR
[P]
DVD
a Disc Tray (DVD deck)
Insert a disc here.
b Cassette Compartment (VCR deck)
Insert a video cassette here.
c POWER 1/:
Switches the unit ON and OFF.
d REW (
mm
)
- DVD: Skip to beginning of current chapter or track,
press twice in quick successions to go to previous
chapter or track. Press and hold button for about two
seconds to search backward.
- VCR: Rewinds the tape during the stop mode or for
fast reverse picture search.
e PLAY (
NN
)
Starts playback of a disc or tape.
f FF (
MM
)
- DVD: Skip to next chapter or track. Press and hold
for two seconds for a fast forward search.
- VCR: Advances the tape during the STOP mode or
for fast forward picture search.
g STOP (
xx
)
Stops playback of the disc or tape.
h PAUSE (
XX
)
Pause playback or recording. Press repeatedly for
frame-by-frame playback.
i OPEN/CLOSE (
ZZ
)
Opens or closes the disc tray.
j Display Windows
Refer to below for details.
k Remote Sensor
Point the unit Remote Control here.
l EJECT (
ZZ
)
Ejects the tape in the VCR deck.
m TRACKING -/+
To adjust tracking.
n REC (
zz
)
To record normally or to activate One-touch Timer
Recording by repeated presses.
Press REC (z) for more than 3 seconds to set the
unit to standby mode for Timer-Link recording.
o VCR/DVD (output select)
Select one of your output sources to view on the TV
screen between DVD and VCR.
p LINE2 (VIDEO/AUDIO (L/R) input)
Connect to the audio/video output of an external
source (Audio system, TV/Monitor, Another VCR).
Front Panel
Display Windows