Filter
Top Products
JVC’s AV compu link feature makes playing video tapes or DVDs totally automatic. Simply
insert a pre-recorded tape into your JVC brand VCR or DVD into your JVC DVD player
and the device will automatically turn on and begin playback. At the same time, using the
AV compu link, the VCR or DVD player sends a signal to the television telling it to turn on
and switch to the proper video input.
• The AV compu link cable may be included with the JVC AV compu link unit you
wish to connect. If it is not, contact JVC Parts Department at (800)-882-2345, or
www.jvcservice.com for part # EWP 805-012.
• AV Compu Link can only be used with JVC brand products.
Notes:
• In order for the VCR playback to begin automatically, the recording tabs must be removed
from the VHS tape. If the tab is in place, automatic switching will occur when you push the
VCR’s PLAY button.
• If your JVC brand VCR has “A code/B code remote control switching” (see your VCR’s
instruction book), using VCR A code will switch the TV to input 1.
• Refer to your DVD instruction book for detailed connection information.
• To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see
the receiver connection instructions for detailed connection information.
• AV compu link is compatible with select AV compu link receivers.
• If you use component connection for your DVD player and the AV Compulink function, you
must set the AV Compulink setting of the DVD to "DVD1".
Connecting to JVC AV Compu Link
Quick Setup Connections
15
AV Compu Link Cable
To Connect: Plug one end of the AV compu link cable
into the AV COMPU LINK INPUT on your VCR, DVD, or
other compu link device. Plug the other end of the AV
compu link cable into the AV COMPU LINK at the rear
of the television.
Note:
• The AV compu link cable has a male 3.5 mm (mono)
plug on each end.
Illustration of AV-36FA54
GJ English 4/24/03, 12:50 PM15