Filter
Top Products
17
10-key pad (0-9)
Press these buttons to select a channel. The channel
number will appear on the upper right corner of the TV
screen. If an invalid channel number is selected, the display
will revert to the original channel.
TV Mode Direct Channel Selection
When the TV/CATV menu option is in the TV position, all
channels can be instantly selected by using two buttons.
(For example, to select channel 2, press
“0”, then “2”. If you
press only
“2”, channel selection will be delayed for a few
seconds). For channels 10 and above, press the 2 digits in
order.
TV - VHF/UHF channels
CATV - CABLE TV channels
To turn on the TV, press the POWER button.
The VOLUME can be adjusted to a desired level by
pressing the VOL (VOLUME) + or – button.
Adjust the volume level by
pressing the VOLUME + or –
button. The volume level will
be indicated on the screen by
green bar. As the volume level
increases, so do the number of
bar. If the volume decreases,
the number of green bar also decreases.
The sound level will be indicated on the TV screen by
green bars and a number. As the sound level in-
creases, so do the number of bars and the number on
the screen. The same is true for decreasing the level.
Set the TV/CATV menu option to the appropriate
position. When shipped from the factory, this menu
option is in the CATV setting. See
“TO MEMORIZE
CHANNELS
”.
TV BASIC OPERATION
CATV Mode Direct Channel Selection
When the TV/CATV menu option is in the CATV position,
channels can be selected as follows:
NOTE: If the station being viewed stops broadcasting, the
TV will automatically shut off after 15 minutes.
CH. 1-9
CH. 10-12
CH. 13-99
CH. 100-125
Press “0” twice, then 1-9 as needed.
Example, to select channel 2, press
“002”.
Press “0”, then remaining 2 digits.
Example, to select channel 12, press
“012”.
Press the 2 digits in order.
Example, to select channel 36, press
“36”.
Press the 3 digits in order.
Example, to select channel 120, press
“120”.
1
2
3
4
CH (CHANNEL) + and – buttons
Press and release the CH
(CHANNEL) + or – button. The
channel automatically stops at the
next channel set into memory.
For proper operation, before selecting channels,
they should be set into the TV’s memory.
See “TO MEMORIZE CHANNELS”.
Before operate your TV select TV position of the TV/CATV
switch on the remote to control the TV with the remote.
RETURN button
Returns to the channel viewed just before the channel
currently onscreen.
VOLUME 32
CH 012
CH 007CH 012
MUTING button
The MUTING button instantly turns the
volume down completely when you
press it.
Press MUTING button and the volume
level will instantly go to zero. To restore
the volume to its previous level, press MUTING button again.
MUTING