JVC AV 32150 CRT Television User Manual


 
Connections 9
To Connect: Plug one end of the AV Compu Link cable into the AV Compu Link input on your VCR or
other Compu Link device. Plug the other end of the AV Compu Link cable into the AV Compu Link input
at the rear of the television.
Illustration of AV-32150
JVC’s AV Compu Link feature makes playing video tapes totally automatic. Simply insert a pre-recorded
tape* into your JVC-brand VCR and the VCR will automatically turn on and begin playback. At the same
time, using the AV Compu Link, the VCR sends a signal to the television telling it to turn on and switch
to the proper video input to watch a video tape.
• The AV Compu Link cable may be included with the JVC AV Compu Link accessory you wish to
connect. If it is not, contact an authorized JVC Service Center for part # EWP 805-012.
• AV Compu Link can only be used with JVC-brand products.
NOTES:
* In order for the VCR playback to begin automatically, the recording tabs must be removed from the VHS tape. If the tab is
in place, automatic switching will occur when you push the VCR’s PLAY button.
• The AV Compu Link cable has a male 3.5 mm (mono) plug on each end.
• If your JVC-brand VCR has “A Code/B Code Remote Control Switching” (see your VCR’s instruction book), using VCR A
Code will switch the TV to Video Input 1. If you use Input 1 for video input from your cable box, use VCR B Code to select
the TV Video Input 2.
• To connect a JVC HiFi receiver or amplifier for a completely automated home theater, see the HiFi’s connection
instructions for detailed connection information.
AV COMPU LINK EX is compatible with the following receivers: RX-664V, RX-665V, RX-668VBK, RX-774V, RX-788VBK,
RX-884V, RX-888VBK, RX-1024V, RX-1028VBK, and later receiver models.
Connecting to JVC AV Compu Link Capable Components
(All models except AV-32115)