JVC HR-S4600U VCR User Manual


 
42 EN
TIMER RECORDING (cont.)
You can directly program the VCR’s timer to record up to 8
shows, as far as a year in advance. Remember, the clock must be
set before you can program the timer ( pg. 8 or 11).
Express Timer
Programming
Turn on the TV and select the VCR channel 3 or 4 (or AV
mode).
JOG
SHATTLE
123
456
7
89
0
2
4
1
3
PROG.
START+/–
STOP+/–
DATE+/–
LOAD A CASSETTE
1
Make sure the record safety tab is intact. If not, cover
the hole with adhesive tape, then load it into the VCR.
The VCR comes on, and the counter is reset,
automatically.
ACCESS VCR PLUS+
SCREEN
2
Press PROG..
ACCESS PROGRAM
SCREEN
3
Press START +/–. (If you’re
just starting out,
“PROGRAM 1” appears.)
SET PROGRAM START TIME
4
Press START +/– to enter
the time you want
recording to start.
Press and hold START
+/– to move in 30-
minute increments, or
press and release
repeatedly to move 1
minute at a time.
SET PROGRAM STOP TIME
5
Press STOP +/– to enter the time you want recording to
stop.
Press and hold STOP +/– to move in 30-minute
increments, or press and release repeatedly to move 1
minute at a time.
SET PROGRAM DATE
6
Press DATE +/–. (The current date is displayed on
screen. The date you enter appears in its place.)
SET CHANNEL NUMBER
7
Press CH +/–.
If you are using a DBS receiver, see "ATTENTION
FOR DBS RECEIVER USERS" on next page.
Holding down CH +/– rapidly scans through the
channels.
CH+/–
PROGRAM 1
START STOP
– –:– –AM = – –:– –AM
DATE CH
– –/– –/– – – – – SP
PRESS (+/–, SP/EP, 8=DAILY,
9=WEEKLY), THEN (0K)
PRESS (PROG.) TO END
PROGRAM 1
START STOP
8:00 AM = – –:– –AM
DATE CH
– –/– –/– – – – – SP
PRESS (+/–, SP/EP, 8=DAILY,
9=WEEKLY), THEN (0K)
PRESS (PROG.) TO END