Filter
Top Products
EN 33
1
3
JOG
SHATTLE
+
−
TIME SCAN
MENU
OK
SKIP SEARCH
MENU
OK
CH
SELECT CA PLAYBACK SET MODE
4
Press CH 5∞ or TIME
SCAN %fi to move the
highlight bar (arrow) to
"CA PLAYBACK", then
press OK or TIME SCAN
#
to set to "AUTO".
● Select "AUTO" to
automatically skip over
CA recorded commercials during playback.
● Select "MANUAL" to manually skip over CA recorded
commercials by pressing SKIP SEARCH.
● Select "OFF" to disable CA Playback of CA recorded
commercials.
● Press SKIP SEARCH during playback, with "MANUAL"
(or "AUTO") selected, to fast-motion the tape to the
end of the next commercial group or to the end of the
recording, and then resume normal playback.
NOTE:
If you press SKIP SEARCH during a commercial, the
VCR may not resume normal playback at the end of the
group of commercial. If this occurs press PLAY or STOP
to resume normal playback.
RETURN TO NORMAL SCREEN
5
Press MENU.
U.S. Pat. No. 5,333,091
ACCESS MAIN MENU SCREEN
1
Press MENU.
ACCESS FUNCTION SET SCREEN
2
Press CH 5∞ or TIME SCAN %fi to move the highlight
bar (arrow) to "FUNCTION SET", then press OK or TIME
SCAN
#
.
SELECT CA RECORD SET MODE
3
Press CH 5∞ or TIME
SCAN %fi to move the
highlight bar (arrow) to
"CA RECORD", then press
OK or TIME SCAN
#
to set
to "ON".
"CA(Commercial Advance) RECORD" and "CA PLAYBACK" are
set to " OFF " at the factory. To set Commercial Advance
perform the following steps to set "CA RECORD" to "ON" and
"CA PLAYBACK" to "AUTO".
NOTES:
●
If you set "CA RECORD" to "ON" while recording is in
progress, the VCR will mark an index code at that location.
●
You cannot change the "CA PLAYBACK" setting during
Commercial Advance fast-motion playback.
●
While recording is in progress with "CA RECORD" set to
"ON", you cannot mark an index code manually, nor change
the recording tape speed.
●
During playback with "CA PLAYBACK" set to "OFF", pressing
SKIP SEARCH starts fast-motion playback for 30 seconds on
the counter (
੬
pg. 35).
●
If there is a power outage while recording is in progress
with "CA RECORD" set to "ON", commercials that are
recorded after the power is restored may not be detected
properly.
●
If you want to stop recording when "CA RECORD" is set to
"ON", be sure to press STOP. If you press POWER or TIMER
to stop recording, that may affect detection accuracy for
commercials recorded afterwards.
PREVIOUS PAGE
FRONT AUX INPUT VIDEO
REAR AUX INPUT VIDEO
=CA RECORD ON
CA PLAYBACK OFF
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
PREVIOUS PAGE
FRONT AUX INPUT VIDEO
REAR AUX INPUT VIDEO
CA RECORD ON
=CA PLAYBACK AUTO
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
FUNCTION
=VIDEO CALIBRATION ON
PICTURE CONTROL AUTO
AUTO TIMER OFF
SUPERIMPOSE ON
AUTO SP
=EP TIMER OFF
DIGITAL R3 ON
NEXT PAGE
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
HR-S7600U-EN24-44 99.4.28, 2:03 PM33