Filter
Top Products
87
Troubleshooting
PROBLEMS CHECK
Static electricity
You hear occasional
crackling sounds
• It is normal to feel static electricity if you brush or touch the screen.
• It is normal for the TV to make crackling sounds when first turned on or off. Unless
the sound or picture become abnormal, this is fine.
There is no sound
from the TV's
speaker
• The Center CH Input may be turned on. See page 57.
• The TV Speaker option may be turned off. See page 56.
The AUTO DEMO
finished automatically
• The TV recieved a signal from the AV CompuLink
• The On Timer that you programmed has started.
• The channel that the AUTO DEMO is using is a channel that is blocked by V-Chip.
• The Auto Shut Off that you programed has occured.
It does not operate
correctly
• Press the CHANNEL- and VOLUME- buttons on the front panel of the TV simultaneously
for a few seconds. The Digital Tuner will be reset. If this does not reset it correctly, unplug
the power cord and plug it back in.
The following are not malfunctions.
• The television may make a creaking sound if the temperature of the room or the
temperature of the inside of the television changes. If there is no problem with the screen or
sound, then there is no need to worry.
• Although the picture may be temporarily disturbed and noise may be seen on the screen if
the power is turned on immediately after it has been turned off, this is not a malfunction.
• If the television is used at a location above 2,000 m, a buzzing noise and image distortion
may occur. This phenomenon is peculiar to PDP (Plasma Display Panel), and could occur
with any television using PDP. It is not a malfunction.
PD-42\50X795 (B) English 87 12/20/04, 9:26:47 AM