Filter
Top Products
12
ENGLISH
Multi CH (CHannel) display
You can browse through all the available programs, up to nine programs at a time.
Blank windows The windows will start
showing snapshots of different
channels in sequence.
After a few seconds....
Symptoms Remedies/Causes
• The unit does not work at all. • Reset the unit (see page 5).
• Check the cords and connections.
• “No Channel” appears on the monitor. No channels have been preset.
• No picture appears when you switch
between functions.
Wait for a few seconds for the unit to return to TV
mode.
• Only sound can be heard and no
picture is shown on the monitor.
• Check the video cables connection.
• This unit might be in radio mode. Press TV/RADIO
to enter TV mode.
• Monitor shows discontinuous,
glitches, or mosaic pictures.
This is not a malfunction. Some broadcasters
are using MPEG-2 signals which are subject to
interference.
• Only picture is shown on the monitor
and no sound can be heard.
• Adjust the sound to the optimum level.
• Make sure the mute function is not activated (see
page 5).
• Check the audio cables connection.
• The monitor screen goes blank and
teletext page does not appear.
• Wait for a few seconds for transmission time.
• The monitor does not support teletext function.
• Check with your local broadcaster for availability of
this service.
• No pictures appear on the Multi CH
(Channel) display.
There may be no broadcast signal.
Troubleshooting
What appears to be trouble is not always serious. Check the following points before calling a service
center.
EN02-13_KV-DT2000[E]f.indd 12EN02-13_KV-DT2000[E]f.indd 12 9/22/05 6:55:09 PM9/22/05 6:55:09 PM