Filter
Top Products
9
SET : BLACK LEVEL (For setting the black level)
7.5 IRE / 0 IRE (Default)
For setting the black signal level of the video signal. When
the video signal is “7.5 IRE Setup”, set to “7.5 IRE”.
SET : DVI Input Level (For setting the gray scale)
16-235 / 0-255 (Default)
OUTPUT FORMAT (ANALOG)
RGB (Default) / YPrPb
Selecting RGB means connecting the processor to the display
via five wire analog RGBHV. This function is not active when
DVI output is selected. DVI is always RGBHV.
COMPOSITE SYNC ON H
On / Off (Default)
● This function is not active when YPrPb output is selected.
● Each input on this unit can be activated or deactivated to
simplify operation so unused inputs are not accessed when
cycling through the inputs with the remote control.
SET : VIDEO INPUT
Enabled (Default) / Disabled
● Disabling this unused input will remove it from the input
menu list.
SET : S-VIDEO INPUT
Enabled (Default) / Disabled
● Disabling this unused input will remove it from the input
menu list.
SET : RGB INPUT
Enabled (Default) / Disabled
● Disabling this unused input will remove it from the input
menu list.
SET : Y/Pr/Pb INPUT
Enabled (Default) / Disabled
● Disabling this unused input will remove it from the input
menu list.
SET : DVI INPUT
Enable / Disable
● Disabling this unused input will remove it from the input
menu list.
SET : PASSTHRU INPUT
Enabled (Default) / Disabled
● Disabling this unused input will remove it from the input
menu list.
SET : PASSTHRU TRANSCODE
Disable (Default) / Enable
YPrPb HDTV signals via the D15 input or the YprPb (BNC)
inputs can be transcoded to RGB when this feature is enabled.
SET : COMPONENT INPUT STANDARD
DVD (Default) / Professional (Betacam)
● Only use professional setting when using a device that
conforms to SMTPE Betacam levels
SET : RGB INPUT SYNC
Sync-on-Green (Default) /Composite Sync
SET : DVI INPUT H SYNC (For setting the H Sync)
Normal (Default) / Wide
SET : OSD (ON SCREEN DISPLAY)
On (Default) / Off
SET : OSD TIMER
0-255 (30 Default)
SET : LCD TIMER
6-255 (40 Default)
● Setting value below 5 will not be displayed. “ALWAYS ON”
is displayed on the LCD display and the backlight is al-
ways lit.
SET : RS232 ECHO
On (Default) / Off
Allows RSR232 characters to be sent back to the controller.
SET : BAUD RATE (For setting the baud rate of
RS-232C)
19200 (Default) / 57600 / 9600
SET : Store NTSC profiles 1-8
SET : Store PAL profiles 1-8
SET : RESTORE FACTORY
Are You Sure? - Press Enter Key
Use this Function only in the event that the processor
no longer functions properly and all other system checks
have been performed. This command will erase all
custom settings and restore the original firmware
configuration. Be sure to go back through the Setup
procedure for proper operation.
The next step in the setup procedure is to align the
display device. Be sure to follow all directions for
setting up the display found in the display’s manual.
Using a test DVD with the Safe Area test pattern,
align the image size, position and blanking first
using the controls found in the display device.
Only use these controls in this unit if the display
device does not offer these controls or if there is
not enough range.
Note
Setup (continued)