Filter
Top Products
13
ENGLISH
How to Use the MAIN MENU
The MAIN MENU contains the functions for daily use.
MAIN MENU
Operation guide
Shows the buttons for
each operation.
7 To exit the menu:
Select
Adjust
7 MAIN MENU items
BACK LIGHT
Adjusts the brightness of the display.
Setting value: 00 - 25
SHARPNESS
Adjusts the clearness of the picture.
Setting value: 00 - 10
CTI.
Adjusts the clearness of the outlines of the color signals
(R/G/B).
Setting value: OFF, NORMAL, HARD
LTI.
Adjusts the clearness of the outlines of the luminance
signal.
Setting value: OFF, NORMAL, HARD
COLOR SYSTEM
Selects the color system.
Setting value: AUTO, NTSC, PAL
NOTE:
• If the picture is unstable with “AUTO,” select “NTSC” or “PAL.”
ASPECT
Selects the aspect ratio.
Setting value: 4:3, 16:9
NOTE:
• Memorized for each input.
ADJ. BAR POSI.
Selects the position of the adjustment bars.
Setting value: UPPER, LOWER
AUTO ADJ.
Adjusts the position of the picture automatically when
analog RGB signals are input from the computer. By
using this function, the picture is displayed as large as
possible in the effective screen area.
• Adjust the items in “SIZE/POSI. ADJ. (RGB)” (☞ page
15) manually when you cannot get a good picture
quality with “AUTO ADJ.”
all reset
Restores all the settings and adjustments of the
monitor to the factory settings.
• Adjustments made by using the buttons on the
front panel will also be reset.
NOTE:
• “HOUR METER X100h” (☞ page 16) and the settings of
“SIZE/POSI. ADJ. (RGB)” (☞ page 15) will not be reset.
• After performing “all reset,” the screen goes back to the
MAIN MENU.
Select “all
reset”
Next
Perform “all reset”
Cancel
Select “AUTO
ADJ.”
Perform “AUTO
ADJ.”
When analog RGB signals are input from the computer
NOTE:
• The menu automatically disappears in about 30
seconds after the last menu operation.
• Some items may not appear on the menu. Those
items are not available for the current input or the
current input signal.
03_LM170&150-EN4.indd 1303_LM170&150-EN4.indd 13 06.7.21 0:39:16 PM06.7.21 0:39:16 PM