Filter
Top Products
Filename [HRS9700EU3.fm]
Masterpage:Left
62
EN
Page 62 July 3, 2000 2:25 pm
EDITING (cont.)
Synchro Editing
The Synchro Editing function synchronizes the start of the
playback and recording operations when starting an edit
operation using a camcorder with LANC connector and your
recorder.
A
Make connections.
Connect your recorder to camcorder (
੬
pg. 51), and
connect your recorder’s SYNCHRO EDIT connector to
the camcorder’s LANC connector.
B
Set the recorder’s input mode.
Press
AUX
(
number key
“
0
”) and/or
PR
to select “F-1” for
the AUDIO and VIDEO input connectors, or “S-1” for the
AUDIO and S-VIDEO input connectors, depending on
the connectors being used.
C
Set the edit mode.
See “PICTURE CONTROL” on page 69.
D
Locate the start point.
Start playback of the tape in the camcorder, and pause
playback when you find the point where you want to start
editing. Press and hold
9
and press
7
on your recorder
so that the recorder enters the Record-Pause mode.
E
Start Synchro Editing.
Press
SYNCHRO
7
/
79
.
F
Pause Synchro Editing.
Press
SYNCHRO
7
/
79
again.
● Repeat steps
4
–
6
as necessary.
NOTES:
● The Synchro Editing function may not work with the initial part
of a camcorder tape.
● The Synchro Editing function cannot be used when using the
JLIP function. (Pressing
SYNCHRO
7/79 cancels the JLIP
function.)
● The Synchro Editing function may not work properly with
some type of camcorder.
● When you select “EDIT” to dub tapes in step
3
, be sure to
select “AUTO” (or “NORM” when “B.E.S.T.” is set to “OFF”)
after you finish dubbing the tapes.
Recorder
Player
LANC cable
(not provided)
SYNCHRO EDIT
connector
Camcorder
To LANC connector
HRS9700EU3.fm Page 62 Monday, July 3, 2000 2:39 PM