Filter
Top Products
31
Recording
EN
Setting a disc to protect
To prevent accidental over-recording, editing or
erasing of recordings, you can protect them using the
Setting menu.
Insert a recordable disc.
1 In stop mode, press [SET UP].
“Easy Setting Menu” or “Advanced Setting Menu”
will appear.
2 Select “Disc” using [Cursor U / D],
then press [ENTER].
3 Select “Disc Protect OFF → ON”
using [Cursor U / D], then press
[ENTER].
4 Select “Yes” using [Cursor U / D],
then press [ENTER].
The disc is protected.
Note
• The Disc Protect setting is available only when a
disc recorded in VR mode is inserted.
• You can select only “Disc Protect ON → OFF” when
a protected disc is inserted.
To cancel the disc protect:
• Select “Disc Protect ON → OFF” at step 3, then
select “Yes.”
• If you insert a disc protected with this unit, “Disc
Protect ON → OFF” will appear instead of “OFF →
ON”.
Finalising discs
You will need to finalise discs to play them back in
other players.
Finalising may take from several minutes up to an
hour. (A disc recorded in Video mode can take up to
15 minutes. A disc recorded in VR mode can take up
to 60 minutes.)
A shorter recording period on the disc will require a
longer time period for finalisation. Do not unplug the
mains cable during finalisation.
Insert a recordable disc before
finalising.
1 In stop mode, press [SET UP].
“Easy Setting Menu” or “Advanced Setting Menu”
will appear.
2 Select “Disc” using [Cursor U / D],
then press [ENTER].
3 Select “Finalise” using
[Cursor U / D], then press [ENTER].
4 Select “Yes” using [Cursor U / D],
then press [ENTER].
Finalising will start.
DVD-RWDVD-RW
VR
DVD-RWDVD-RW
Video
DVD-RWDVD-RW
VR
DVD-RDVD-R
Finalise
No
Yes
E6851BD_EN.book Page 31 Tuesday, August 2, 2005 5:57 PM