Filter
Top Products
References
60
DVD Playback
PROBLEM POSSIBLE CAUSE SOLUTION
No sound. The system cord and/or speaker cord is not connected. Check the connection. (
A
pg. 10 – 13)
There is a short in the speaker cord. Reconnect the speaker cord.
The audio cord is not connected to AUX IN and/or
DIGITAL IN correctly.
Connect the cord correctly. (
A
pg. 14)
An incorrect source has been selected. Select the correct source. (
A
pg. 20)
Muting is on. Press
MUTING
to cancel muting. (
A
pg. 20)
The decode mode is not set correctly. Select the proper decode mode. (
A
pg. 22)
Sound from one front
speaker only.
The speaker cord is not connected correctly. Connect the speaker cord correctly. (
A
pg. 10)
Left-right balance is not set properly. Adjust the balance properly. (
A
pg. 53, 58)
No sound from the
center and/or surround
speakers.
The speaker setting is incorrect. Set the speaker setting properly. (
A
pg. 53, 58)
Bass sound is heard
reinforced when
listening in stereo.
Appropriate bass level for stereo sound is not selected. Set “AUDIO POS” properly. (
A
pg. 58)
PROBLEM POSSIBLE CAUSE SOLUTION
No picture is displayed
on the TV screen.
The video cord or SCART cable is not connected
correctly.
Connect the cord correctly. (
A
pg. 8)
The RGB-Y/C selector is not set correctly. Set the selector properly for the video input format of
the connected TV. (
A
pg. 8)
TV input selection is incorrect. Select the correct input on the TV.
The disc is not playable. Use a playable disc. (
A
pg. 3)
A disc cannot be played. The center unit’s and disc’s Region Code numbers are
incompatible.
Replace the disc. (
A
pg. 3)
Parental Lock is in use. Enter password to change the Parental Lock level.
(
A
pg. 55)
A disc cannot be played
and “0:00” is displayed
on the display window.
The disc is loaded with its label and data sides inverted. Load the disc correctly. (
A
pg. 23)
The unplayable disc is loaded. Replace the disc. (
A
pg. 3)
Video and audio are
distorted.
The disc is scratched or dirty. Replace or clean the disc. (
A
pg. 2)
A VCR is connected between the center unit and the
TV.
Connect the center unit and TV directly. (
A
pg. 8)
With some discs, a picture may be blurred when setting
“PICTURE SOURCE” to “FILM” or “AUTO”.
Set “PICTURE SOURCE” to “VIDEO (NORMAL)” or
“VIDEO (ACTIVE)”. (
A
pg. 53)
The picture does not fit
the TV screen.
The monitor type is not set correctly. Set “MONITOR TYPE” properly. (
A
pg. 53)
The TV is not set correctly. Set the TV properly.
No subtitle appears on
the TV screen though
you have selected a
certain language as your
initial subtitle language.
—
Some DVDs are programmed to always display no
subtitle initially. If this happens, press
SUBTITLE
on
the remote control after starting play. (
A
pg. 43)
Audio language is
different from the one
you have selected as
your initial audio
language.
—
Some DVDs are programmed to always use the original
language initially. If this happens, press
AUDIO
on the
remote control after starting play. (
A
pg. 43)
TH-A85-55[B].book Page 60 Friday, March 28, 2003 12:01 PM