Filter
Top Products
47
ENGAGE INSERT EDITING
6
Press INSERT.
● Your VCR enters the Insert-Pause mode. (REC, PLAY
and PAUSE light up on the front display panel.)
● The TV screen changes from the still picture to the
input signal you are going to record.
START EDITING
7
Load the source cassette and play back the segment
that is to be inserted. Then press PLAY to start the tape
in your VCR; Insert Editing begins at this point.
● PLAY and REC are displayed on the front display
panel.
END INSERT EDITING
8
At counter "0H00M00S", Insert Editing will stop automati-
cally while the tape continues running in the Play
mode. if you wish to stop Insert Editing before the
specified edit-out point, press C.RESET.
FOR AV INSERT EDITING
If you want to replace the picture, Hi-Fi audio soundtrack and
normal audio soundtrack all at the same time...
In step 6 above, after you press INSERT, press A. DUB. also.
(REC and PLAY blink and PAUSE lights up on the display panel.)
12
45
3
6
8
0
7
9
6
q
PLAY
C.RESET
NOTES:
●
Suitable leads can be obtained from your dealer.
●
Insert editing is not possible with cassettes whose safety tab
has been removed.
●
In insert editing, the recording speed (SP/EP) is determined by
the previous recording to be replaced. If the previous
recording's speed changes within a single edit, the inserted
picture will be distorted at the switching point.
●
Insert Editing is also possible using the rear connectors.
When using these connectors, be sure to select "REAR" at the
Aux Input screen. To select the correct AUX Input connector,
follow steps 4, 5, 9 – 11 from the "Edit From A Camcorder"
section,
੬
pg 42.
PLAY
INSERT