Filter
Top Products
24 EN
COLOUR
SYSTEM
AUTO
NTSC 3.58
NTSC 4.43
NTSC
PAL*
PAL
MESECAM
SECAM*
INFORMATION ON MULTI-SYSTEM COMPATIBILITY
Setting Of The Colour System Select Buttons
Use the COLOUR SYSTEM button on the front panel to select
the colour system. Pressing this button changes the mode as
illustrated on the left. The On-Screen display will show which
mode is selected.
Mode Description
AUTO Usually set to this mode. This mode
automatically detects PAL, NTSC, SECAM
or MESECAM and adjusts to the colour
system being recorded or played back.
When it does not perform properly, set the
colour system manually.
MANUAL For recording, there is a choice of 4
selectable modes; PAL/MESECAM/NTSC
3.58/NTSC4.43. Select the mode that
matches the colour signal being received.
For playback, there is an additional mode
which allows NTSC tapes to be played
back and viewed on PAL TVs.
NOTES:
●
In the AUTO mode, NTSC signals will be automatically
recorded as NTSC 3.58.
●
In the AUTO mode, NTSC tapes will be played back as NTSC
3.58.
●
SECAM signals will always be recorded as MESECAM. Select
the AUTO or the MESECAM mode when recording SECAM
signals.
●
When playing back a SECAM tape, select the AUTO,
MESECAM or SECAM mode. The playback picture will always
be monochrome in modes other than the SECAM mode. Be
sure to select the AUTO mode after you finish viewing a
SECAM tape in the SECAM mode.
●
For SECAM tapes, only SP recordings can be played back on
this recorder.
●
In the NTSC4.43 mode, with some TVs, on-screen displays
(Program screen etc.) may roll up or down and there may be a
loss of colour. When this happens, select the AUTO mode.
Off-Air Recording
The built-in multi-system tuner is capable of receiving PAL B/G, I and D/K, and SECAM B/G and D/K and NTSC broadcasts.
PAL B/G, I, D/K
NTSC (M)
SECAM B/G,
D/K (OIRT)
PAL
MESECAM
NTSC 3.58
PAL
MESECAM
NTSC
TV system Recorded tape
Recording circuit
HR-J457MS
NOTE:
This model does not operate in BRAZIL (PAL-M) or ARGENTINA (PAL-N).
Multi-system
tuner
(B/G, I, D/K, M)
Mode Display
* "NTSC[PAL" and "SECAM" appear during playback only.