JVC XV-BP11 DVD Player User Manual


 
18
[LANGUAGE] Menu
Display Menu
Select a language for the [Setup] menu and on-
screen display.
Disc Menu / Disc Audio / Disc Subtitle
Select the language you prefer for the audio track
(disc audio), subtitles, and the disc menu.
[Original] – Refers to the original language in
which the disc was recorded.
[Other] – Press ENTER to select another lan-
guage. Use number buttons then ENTER to
enter the corresponding 4-digit number accord-
ing to the language code list on page 29.
[Off] (for Disc Subtitle) – Turn off Subtitle.
Note:
Depending upon the disc, your language setting
may not work for some discs.
[AUDIO] Menu
Each disc has a variety of audio output options. Set
the player’s Audio options according to the type of
audio system you use.
Note:
Since many factors affect the type of audio output,
see “The unit’s Audio Output Specifications” on page
32 for details.
HDMI / SPDIF (Digital Audio Output)
Select the output sound format when a device
equipped with an HDMI or Digital Audio input jack is
connected to the HDMI OUT or DIGITAL AUDIO
OUT jack on this player.
[PCM Stereo] – Select if you connect this unit’s
HDMI OUT or DIGITAL AUDIO OUT jack to a
device with two-channel digital stereo decoder.
[PCM Multi-Ch] (HDMI only) – Select if you
connect this unit’s HDMI OUT jack to a device
with multi-channel digital decoder.
[DTS Re-Encode] – Select if you connect this
unit’s HDMI OUT or DIGITAL AUDIO OUT jack to
a device with DTS decoder.
[Primary Pass-Thru] – Select if you connect this
unit’s DIGITAL AUDIO OUT and HDMI OUT jack
to a device with LPCM, Dolby Digital, Dolby
Digital Plus, Dolby TrueHD, DTS and DTS-HD
decoder.
Notes:
When [HDMI] option is set to [PCM Multi-CH], the
audio may output as PCM Stereo if the PCM
Multi-Ch information is not detected from HDMI
device with EDID.
If the [HDMI] or [SPDIF] option is set to
[DTS Re-Encode], the DTS Re-encode audio is
outputted for BD-ROM discs with secondary audio
and the original audio is outputted for the other
discs (like [Primary Pass-Thru]).
Sampling Freq. (Only for SPDIF audio)
[192KHz] – Select this if your A/V Receiver or
Amplifier is capable of handling 192 KHz signals.
[96KHz] – Select this if your A/V Receiver or
Amplifier is NOT capable of handling 192 KHz
signals. When this choice is made, this unit auto-
matically converts any 192 KHz signals to
96 KHz so your system can decode them.
[48KHz] – Select this if your A/V Receiver or
Amplifier is NOT capable of handling 192 KHz
and 96 KHz signal. When this choice is made,
this unit automatically converts any 192 KHz and
96 KHz signals to 48 KHz so your system can
decode them.
Check the documentation for your A/V Receiver or
Amplifier to verify its capabilities.
DRC (Dynamic Range Control)
When a disc encoded in Dolby Digital or Dolby
Digital Plus is playing back, you may wish to com-
press the dynamic range of the audio output (the dif-
ference between the loudest sounds and the qui-
etest ones). This allows you to listen to a movie at a
lower volume without losing clarity of sound. Set
DRC to [On] for this effect.
Note:
The DRC setting can be changed only when a disc
is not inserted or the unit is in complete stop mode.
BD320-JN_BUSAJJK_OM_ENG 8/31/09 12:16 PM Page 18