Filter
Top Products
Initial settings
57
Initial settings
English
• STREAM/PCM
Should be selected when you connect to the digital
input of an amplifier with a built-in DTS, Dolby Digital,
or MPEG multichannel decoder.
• DOLBY DIGITAL/PCM
Should be selected when you connect to the digital
input of a Dolby Digital decoder, or an amplifier with a
built-in Dolby Digital decoder.
The following chart shows the relationship between
types of playback discs and output signals.
* With some DVD VIDEO discs that are not fully copy-
protected, a 20 or 24 bit digital signal may be output.
DOWN MIX
To playback a DVD VIDEO
disc recorded with
surround multichannel
audio correctly, the DOWN
MIX setting must be
properly made according to
your audio system.
Note that this setting affects
only the output signal from the ANALOG AUDIO output
jacks when playing back a DVD VIDEO disc recorded with
surround multichannel audio.
•Lt/Rt
Should be selected when you enjoy multichannel
surround audio by connecting the unit’s ANALOG
AUDIO output to a surround decoder.
•L
0
/R
0
Should be selected when you enjoy conventional 2-
channel stereo audio by connecting the unit’s AUDIO
output to a stereo amplifier/receiver or television set,
or when you duplicate audio of a DVD VIDEO disc
recorded with surround audio to your MD, cassette,
etc.
•OFF
When you enjoy multichannel surround audio by
connecting the unit's 5.1-channel audio outputs to an
amplifier equipped with 5.1-channel inputs.
Playback discs
Output
STREAM/
PCM
DOLBY
DIGITAL/
PCM
PCM ONLY
DVD with 48/44.1
kHz, 16 bit linear
PCM
48/44.1 kHz,
16 bit, stereo
linear PCM
++
DVD with 48/44.1
kHz, 20/24 bit
linear PCM
48/44.1 kHz,
16 bit, stereo
linear PCM*
++
DVD with 96/88.2
kHz, linear PCM
No output
++
DVD with 192/
176.4 kHz, 16/22/
24 bit linear PCM
No output
++
DVD with DTS DTS bitstream 48 kHz, 16 bit,
stereo linear
PCM*
+
DVD with Dolby
Digital
Dolby Digital
bitstream +
48 kHz, 16 bit,
stereo linear
PCM*
Video CD 44.1 kHz,
16 bit, stereo
linear PCM
++
Audio CD 44.1 kHz,
16 bit,
stereo linear
PCM
++
Audio CD with DTS
DTS bitstream 44.1 kHz,
16 bit, stereo
linear PCM
+
CD-R/RW with MP3
No output ++
NOTE
• When playing a DVD VIDEO or Audio CD disc with DTS,
use a DTS decoder to get correct signals from your
speakers.
NOTES
• The “DOWN MIX” function does not work when the 3D
PHONIC function is activated.
• Some DVD AUDIO discs prohibit the 2-channel down-
mix. For such a disc, you cannot get the down-mixed
signal even if you set “DOWN MIX” to “Lt/Rt” or “Lo/
Ro”.
PREFERENCE2PREFERENCE1 SPK. SETTING
DIGITAL AUDIO OUTPUT
STREAM/PCM
DOWN MIX
Lo/Ro
COMPRESSION
DTS BASS MANAGEMENT
ON
OFF
AUTO STANDBY
OFF
SCREEN SAVER
SELECT KEY
MODE1
AV COMPULINK MODE
DVD1
3HQJIP3DJH)ULGD\-XQH30