Filter
Top Products
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity. Print only
what is inside the frame.
4 PPG 37241 - 120501
Assembly page 4/20
Fax +1 305 430 9692
MAINTENANCE
Disassemble the different parts of the appliance and clean them
separately with a damp cloth. Do not immerse the mill in liquid or put
it in a dishwasher. Do not use with wet hands. Do not use cleaning
products or detergents.
BATTERIES
If your appliance does not work properly, it is probably because the
batteries are discharged. In that case, replace them with new ones
of the same type (see “Before use”).
Please eliminate the old batteries in an environmentally friendly way.
TROUBLESHOOTING
If the mill does not grind, or if no motor noise can be heard, please
check that the batteries are installed correctly and are not
discharged. For best results we recommend alkaline batteries.
If the mill gets stuck during use (motor produces hum, but internal
shaft does not turn and no pepper is ground], gently shake the mill or
tap the mill gently on a hard surface, to remove the stuck pepper or
salt.
To remove deeply stuck peppercorn, remove the upper lid as if for
re-filling the mill, turn the coarseness setting to its coarsest, and tap
lightly on a hard surface until all the peppercorn is released. Re-
adjust coarseness setting to the desired level once done and
replace upper lid.
Note: Too fine a grind setting may not enable salt or pepper to be
ground. If this is the case, set the grinder to a coarser setting (see
above).