Filter
Top Products
Sat Operation
31
Submenu for entering DiSEqC commands
This submenu is called up by pressing the button „tx input“ in the DiSEqC menu.
Entry
The hex number, where the cursor is posi-
tioned, is displayed and flashes. This hex
number can be edited with the numerical
button field (1-9), with one of the softkey
buttons (A to F) or with the buttons ▲ and
▼. The switch to the next character occurs
with the cursor buttons, ◄►. The four
code words - Framing (FRAME), Address
(ADD), Command (COM) and Data
(DATA) – are located in abbreviated form
above the appropriate hex codes. Press
the ENTER button to exit the menu.
Refer to the technical appendix of this operating manual for an overview of
the DiSEqC commands.
TX display field
In the TX display, the DiSEqC commands can be edited, which
are transmitted from the MSK 33 to another DiSEqC unit. The
buttons, ◄ and ►, are used here as cursor buttons. With the
buttons, ▲▼, the hex code can be gradually increased or
decreased.
Display field A
In this display field, the DiSEqC command, which is given in the
TX display field, is displayed:
Display field B
In this display field, a brief explanation of the selected DiSEqC
command is displayed.
If a DiSEqC command is entered-in , which is not listed in the
MSK 33, this display will appear.