Filter
Top Products
Copy Menu
61
Copy Menu
The copy menu is called up with the copy
button. Exit the menu by pressing the but-
ton once more.
Saving and calling up unit settings
Saving the unit settings
One hundred memory positions (00-99) are available for saving the settings of the
unit. First, select the unit setting, which is to be saved, and then call up the COPY
menu. By pressing the softkey „store nr. --“ and entering a second digit by means
of the numerical buttons, the last set unit setting is saved under the selected mem-
ory position.
The saved settings are displayed on the screen in abbreviated form:
No.
Operating
type
Frequency (MHz) Meaning
0 T A 210.25M TV analogue
1 T s A 319.25M TV Special channel analogue
2 T D 213.00M TV digital
3 T s D 338.00M TV Special channel digital
4 S A 1597.00M SAT analogue
5 S D 1990.00M SAT digital
6 R A 98.00M Radio analogue
You can scroll down the setting list by using the cursor buttons, ▲▼.
Calling up saved settings
Saved settings can be called up by entering the memory position. By pressing on
this button, the field „recall nr.—“ lights up yellow. Now, the position of the desired
memory position can be typed with the numerical buttons. If the called up memory
position is not found, the message „NO SETTINGS FOUND“ appears on the
screen.
The saved settings are not deleted during a software update, but can be written
over by new settings. The memory positions 80...95 are occupied at the factory
with the most important DiSEqC commands.
Calls up the panoramic printout menu
This softkey no longer applies to the software versions 7.0 and higher. The pano-
ramic printout can only be carried out via the spectrum analysis with the command
„COPY“ and „print data.“