Filter
Top Products
6
Proper use
The MobiSet 3 digital CAP 310 is designed to receive digital TV and
radio programs via satellite. The turntable is intended for the Kathrein
planar antenna BAS 60. This antenna can be used to receive digital
TV and radio signals in the frequency range from 10.70 to 12.75 GHz;
the antenna cannot receive terrestrial signals (e.g. DVB-T).
The turntable can only be used in conjunction with a Kathrein
UFD 170 combi receiver or the Kathrein UFD 540 digital receiver and
HDS 160 control unit. In conjunction with these two receivers, the
turntable provides fully automatic alignment of the planar antenna to
receive digital satellite signals. The turntable is designed for use in
stationary caravans or motorhomes.
Any use other than that specifi ed above will void the warranty or
guarantee.
The following circumstances result in the loss of all warranty
and liability claims towards the manufacturer:
• Improper installation
• Use of non-specifi ed mounting materials, which cannot guarantee
the mechanical reliability of the antenna system
• Non-permissible use, e.g. use of the planar antenna for storage
• Structural changes or interference with the components and mounting
accessories in the set, which could endanger both the mechanical
and functional reliability
• Improper or forcible opening of the components
• Use of cleaners containing solvents, such as acetone, nitro-cellulose
combination thinner, naphtha etc.
• Failure to observe installation and safety instructions in this manual
Proper use
Note: The maximum permissible speed for vehicles with a BAS 60/HDP 171
receiver unit mounted on the roof is 130 km/h. Before commencing
a journey, the planar antenna must always be lowered into horizontal
position (park position).
The turntable may be operated in an ambient temperature range of
-10 °C to +40 °C. Operating the system outside these ranges can
result in malfunctions or damage to the system.
Intended purpose
The turntable may only be assembled by qualifi ed specialist
personnel.
To prevent hazards during installation, operation or when driving on
public highways, the instructions and information in this manual must
be strictly adhered to. Proper installation and connection of the system
are pre-requisites for conformity with the corresponding standards.
This has been documented in advance in the CE label and the
declaration of conformity in the appendix to this manual.
Installation instructions