Filter
Top Products
74
CONNECTING UP THE VIDEO/PVR
For details of how to connect your external recorder to the receiver refer to the connection diagram
provided at the end of this manual and the instructions for the external recorder.
In order to make a PVR recording (Record), the satellite receiver must be switched on or the timers must
be pre-programmed (see “EPG” “Recording (timer)” section).
For VCR/PVR playback you must have previously set the UFS 710 Scart socket to “VCR mode” (Scart
changeover), using the
button, so that the signal path is set up from the VCR or PVR/AUX Scart socket
to the TV Scart socket.
In this setting, the picture from the external recorder is switched through to the TV set during playback.
Pressing the
button again a second time restores priority to the UFS 710 “Scart → Sat” signal.
In the setting “Scart → TV” (TV mode) the internal tuner of the TV set has priority and you cannot then
see the signal from the receiver on the screen unless you switch the TV set to the AV channel.
The settings “VCR mode” and “TV mode” are shown in the display on the receiver.
RECORDING
PLAYBACK