Filter
Top Products
17
Satellites and position
Use the
buttons to set the desired satellite
(selection from 17 pre-programmed options).
LNB settings
Here use the
buttons to select the LNB
type used in your system. The choice is between
“Universal” and “User-defi ned”.
Universal:
No further input required, since all necessary
frequency ranges are covered by a universal LNB.
User-defi ned:
If you choose not to use a universal LNB, you must
here set the frequency ranges for which your LNB
was confi gured.
Use the
buttons to select the frequency
range to be changed (low, high or limit frequency).
Use the
buttons or the digital input
buttons to set the exact frequency for which your
LNB was confi gured.
Test transponder
To check whether the settings that you have
made are correct, use the
buttons
to move to the “Test transponder” fi eld.
Use the
buttons to select the required
transponder from the various ones listed. If your
settings are correct, you will see at the top right of the
screen the live signal of a channel for the currently
selected transponder.
If you are not receiving a signal, check your
settings again and if necessary call for expert
help.
You have now completed all settings for the fi rst
satellite. Press the
button to return to the
“Satellite Selection Menu” and perform the settings
in the same way for the remaining satellites.
The notes on fi rst installation are unifi ed once again from this point!
When you have fi nished confi guring the satellite press
!
(green) button. The receiver then automatically
calls up the selection menu for the channel search.
FIRST INSTALLATION