Filter
Top Products
• Do not ground to a gas pipe.
• Check with a qualified electrician if you are not sure the
washer is properly grounded.
• Do not have a fuse in the neutral or ground circuit.
1 2 ...........................
................3
1.3 prong grounding plug
2. 3 prong grounding-type
wall receptacle
3. Grounding prong
4. Power supply cord
INSTALLATION
INSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install
washer.
Failure to do so can result in back or other injury.
IMPORTANT: Position the washer so that the rear of the unit is
within approximately 3 ft (90 cm) of the final location.
There are 4 bolts in the rear panel of the washer that support the
suspension system during transportation. These bolts also retain
the power cord inside the washer until the bolts are removed.
GROUNDING mNSTRUCTmONS
For a grounded, cord-connected washer:
This washer must be grounded. Hnthe event of a
maHfunction or breakdown, grounding wHHreduce the
risk of eHectricaH shock by providing a path of Heast
resistance for eHectric current. This washer is
equipped with a cord having an equipment-grounding
conductor and a grounding pHug. The pHug must be
pHugged into an appropriate outHet that is properHy
instaHHed and grounded in accordance with aHHHocaH
codes and ordinances.
WARNING: Hmproper connection of the
equipment-grounding conductor can resuHt in a risk of
eHectric shock. Check with a quaHified eHectrician or
serviceman if you are in doubt as to whether the
appHiance is properHy grounded.
Do not modify the pHug provided with the appHiance -
if it wiHHnot fit the outHet, have a proper outHet instaHHed
by a quaHified eHectrician.
For a permanentJy connected washer:
This washer must be connected to a grounded metaH,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminaH or
Head on the appHiance.
1.
2.
Using a 13 mm wrench, loosen each of the bolts.
Once the bolt is loose, move it to the center of the hole and
completely pull out the bolt, including the plastic spacer
covering the bolt. The power cord will be attached to all
4 bolts inside the washer.
3. Once all 4 bolts are removed, pull the power cord through the
opening of the rear panel and close the hole with the attached
cap.
4. Close the bolt holes with the 4 transport bolt hole plugs.
NOTE: If the washer is to be transported at a later date, call
your local service center. To prevent suspension and structural
damage, your machine must be properly set up for relocation
by a certified technician.