Filter
Top Products
Mounting on Pickup Trucks
The antenna module should be mounted on the centerline of the roof approximately
4 inches from the rear of the cab. The cables may be routed into the cab through
the brake light cavity.
Figure 29: Pickup truck with antenna module
1. Follow steps 1 to 4 under "Installing on Sedans" to attach the antenna module
to the vehicle.
Note: If the molding of the brakelight is made of rigid plastic/composite, it may be
necessary to drill a small hole or slot to route the cable. Seal the hole with silicone
compound after the installation.
Figure 30: Brakelight cavity
Figure 31: Completed installation
2. Route the cable through the interior trim to where the receiver is located.
3. See Figure 19 under "Installing on Sedans" for connection to the receiver.
14
It is important that the coaxial cable does not become damaged
or kinked during the installation procedure.