Filter
Top Products
DVF-3080/DVF-8100 (EN/K,P,E,X,Y)
Set Up functions
14
Preparations
LANGUAGE AUDIO
Menu Language
Select a language for the Setup menu and on-screen
display.
Disc Audio/ subtitle/ Menu
Select the language you prefer for the audio Track (disc
audio), subtitles, and the disc menu
Original: Refers to the original language in which the
disc was recorded.
Other: To select another language, press number but-
tons then ENTER key to enter the corresponding digit
number according to the language code list in the refer-
ence chapter. If You enter the wrong Language code,
press CLEAR key.
DISPLAY
TV Aspect
4:3: Select when a standard 4:3 TV is connected.
16:9: Select when a 16:9 wide TV is connected.
Display Mode
Display Mode setting works only when the TV Aspect
mode is set to "4:3".
Letterbox: Displays a wide picture with bands on the
upper and lower portions of the screen.
Panscan: Automatically displays the wide Picture on the
entire screen and cuts off the
portions that do not fit.
Progressive Scan
When ON is selected, the confirmation screen for switch-
ing to Progressive Scan appears.
In case of a TV not compatible with Progressive Scan, the
screen disappears and return to the original display is
made after 10 seconds.
TV Output Select (only for Europe)
The TV Output Select mode is switched to RGB or YCbCr.
TV Aspect 16 : 9
Display Mode Widescreen
Progressive Scan Off
TV Output Select RGB
Each DVD disc has a variety of audio output options. Set
the player’s AUDIO options according to the type of
audio system you use.
Dolby Digital/ DTS/ MPEG
Bitstream: Select "Bit stream" if you connect the DVD
Player’s DIGITAL OUT jack to an amplifier or other
equipment with a Dolby Digital, DTS or MPEG de-
coder.
PCM (for Dolby Digital/ MPEG): Select when con-
nected to a two-channel digital stereo amplifier.
DVDs encoded in Dolby Digital or MPEG will be auto-
matically down mixed to two-channel PCM audio.
Off (for DTS): If you select “Off'', the DTS signal is
not output through the DIGITAL OUT jack.
Sample Freq. (Frequency)
If you receiver or amplifier is NOT capable of handling 96
kHz signals, select 48 kHz. When this choice is made, this
unit automatically converts any 96 kHz signals to 48 kHz
so your system can decode them.
If your receiver or amplifier is capable of handling 96 kHz
signals, select 96 kHz. When this choice is made, this unit
passes each type of signal through without any further
processing.
Check the documentation for your amplifier to verify its
capabilities.
When the disc prohibits 96 kHz digital output, the signal
always is put out after down-conversion.
Dynamic Range Control (DRC)
With the DVD format, you can hear a program's
soundtrack in the most accurate and realistic presenta-
tion possible, thanks to digital audio technology. How-
ever, you may wish to compress the dynamic range of
the audio output (the difference between the loudest
sounds and the quietest ones). This allows you to listen
to a movie at a lower volume without losing clarity of
sound. Set DRC to On for this effect.
This function operates only at the time of playback of
DVDs recorded with Dolby Digital.
Vocal
Set to on only when a multi-channel karaoke DVD is
playing. The karaoke channels on the disc mix into nor-
mal stereo sound.