Filter
Top Products
59
Chapter 6:Specifying and Using Disc or Track Data
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
6-3-5 Assigning user file names
(FILE NAME INPUT mode)
Although all operations can be controlled from
both the standard remote and Keyboard remote
control units, do not change the remote control
unit in the middle of operation such as character
input. Otherwise, characters may not be input
correctly. (DV-5900M only)
4. Press the DISC + (up), – (down) button to select
“U.FILE INIT.”, then press the SET button.
5. Press the DISC + (up)/– (down) button to select a
user file number (1 to 8) and press the SET button.
÷ If user file names have already been registered, their
names are displayed.
“Assigning user file names” O
÷ The display on the main unit shows “FILE
INITIAL ?”.
6. Press the SET button.
÷ The “User file INIT.” mode is finished.
Capital letters :
ABC.....XYZ.....
Small letters :
abc.....xyz.....
Numbers/symbols :
0 1 2 3.....7 8 9 space ! " # $
% & ' () * + , - . / : ; < = > ?
@ ^ _ ` .....
OV LE IFE≤ZAB
OV LE IFE≤zab
OV LE IFE≤9 !
a : Operation using the standard remote
control unit
Operation procedure
1. Check that the unit is in the normal play TRACK
mode. ¤
2. Press the MODE button.
÷ When the MODE button is pressed during USER
NAME INPUT mode, the FILE NAME INPUT mode
is cancelled.
3. Press the DISC + (up), – (down) button to select
“USER FILE”, then press the SET button.
4. Press the DISC + (up), – (down) button to select
“NAME INPUT”, then press the SET button.
5. Press the DISC + (up), – (down) button to select the
user file number you want to assign a file name, and
press the SET button.
To change the character type
Press the CHARAC. button repeatedly until the characters
of the desired character type are displayed.
6. Enter the file name using the character input buttons.
÷ If a desired character is not provided on the remote
control buttons, input the character as follows.
Press the CHARAC. 4, ¢ (down/up) buttons
or rotating the DISC knob on the main unit until
the desired character is displayed in the flashing
cursor position. Then, press the SET button.
÷ The type of characters (capital letters or numbers/
symbols) is switched each time the CHARAC.
button is pressed.
÷ A file name can be registered using up to 20
characters.
÷ If you commit a mistake in the character button
input, press the DELETE button and restart the
input from the beginning. P
÷ To enter a space, press the SPACE button.
7. Press the ENTER button.