Filter
Top Products
63
Removing Monitor Unit
Removing the Hard Rubber Frame
■
Accessory J
Engage the catch pins on the removal tool and remove
the two locks on the lower level.
Lower the frame and pull it forward as shown in the
figure.
When the lower level is removed, remove the upper two
locations.
The frame can be removed from the top side in the same
manner.
NOTE
2
1
Refer to the section “Removing the Hard Rubber Frame” and then
remove the hard rubber frame.
Remove the Hex-head screw with integral washer (M4×6) on the
back panel.
Insert the two removal tools deeply into the slots on each side, as
shown.
Lower the removal tool toward the bottom, and pull out the unit
halfway while pressing towards the inside.
Be careful to avoid injury from the catch pins on the removal tool.
Pull the unit all the way out with your hands, being careful not to
drop it.
5
2 CAUTION
4
3
2
1
Removing the Unit
■
Catch facing up
Catch
Lock
KVT_911DVD_Eng_01 02.1.25 2:25 PM Page 63