Filter
Top Products
HELIX DN9340E/DN9344E Remote Control Software
User Guide
16 of 65
5.2 Parametric Equalisation
To switch to the Parametric Equalisation view
Click on the Para button of the Channel A or B Navigation Strip, as required. (If staying on
the same Channel, you may prefer to click on a Parametric tab).
The upper Parametric Mode tab is used to set the EQ characteristic (EQ type), bypass state and graph
display mode (when a DN9340) for the current channel. The lower Parametric Shaping tab provides a
series of PEQ control panels for added PEQ sections. PEQ sections can also be adjusted at the display
by using the ‘target cursor’.
To set the Parametric EQ mode for the channel
1 Select a Proportional, Constant, or Symmetrical Q
characteristic from the EQ Type drop down menu
(right).
2 Use the Unit Display drop down menu to set the
Parametric display mode that the HELIX unit should
assume when taken out of slave operation; this
only comes into effect if the slave is a DN9430.
The choice made here has no effect on your AddIn
device display.
Note
Refer to the DN9340/DN9344 Operators Manual for application notes on Equalisation modes
and Q.
PEQ sections
are adjusted
by dragging
the ‘target’ o
r
setting values
Parametric Mode
tab
The black graph
shows combined
EQ. The red
graph shows the
response of the
selected PEQ
section
PEQ panels
appear as
you add PEQ
sections
Tick the check box to switch the
PEQ section out of the circuit
Parametric
Shaping tab