Filter
Top Products
HELIX DN9340E/DN9344E Remote Control Software
User Guide
52 of 65
To recall settings from a User or Preset memory from the HELIX Unit to the AddIn
Device
1 In the upper Memory tab, select the Current PC Memory that you wish to overwrite.
2 Set the AddIn Device online.
3 In the lower Memory tab’s left-hand panel, select the required Unit Memory location from
the associated drop down list. (The Current PC Memory No. is not affected by the recall
Unit’s memory number since only the settings are recalled.)
4 Click on Recall Unit Memory. You are warned that the current memory will be overwritten, and
asked to confirm the action.
5 Click OK to continue or Cancel to abort.
The memory settings are uploaded to the Current PC Memory and the graphic display is updated. The
recalled frequency response can now be edited by changing the settings in the various Equalisation tabs,
working on or offline as appropriate.
To retrieve all the Memories from a Unit to the AddIn Device
1 Set the AddIn Device online.
2 In the lower Memory tab’s right-hand panel, select Read All Memories.
3 Click OK at the prompt to confirm the overwriting of the PC memories.
As retrieving all 64 memories takes a couple of minutes, the HELIX RCS presents a Status window so
that you can track the current progress. When the operation is complete, the Status window
disappears.
To write all the Memories from the AddIn Device to the unit
1 If you wish to write settings to the Preset memories, ensure they are unlocked at the Unit.
(If they are locked, only the User memories will be overwritten).
2 Set the AddIn Device online.
3 In the lower Memory tab, select Write All Memories.
4 Click OK at the prompt to confirm the overwriting of the Unit memories.
PC memories are sent in numerical order such that the User
Memories are overwritten first, then the Presets; a Status
window tracks the current progress. If Presets are locked, you
are prompted to unlock them. If you click OK without unlocking
them the Write All action is aborted; only the User Memories will
have been transferred.
To copy settings from a Unit’s User Memory to a
Preset Memory
1 Select a PC Memory Location between 33 and 64 which is unused or whose current settings
are no longer required. This will force the unit offline.
2 Set the Unit online.
3 Recall the User memory from the unit, as described above.
4 Store the settings to the Unit using the Write All command, as described above.