Filter
Top Products
20
Video connection to a TV/ Beamer with component video inputs
(YCbCr /YPbPr)
Component video separates the video signal into three separate “components”,
resulting in a higher picture quality than S-Video or standard composite video.
In order to use component video, you have to use a TV/Beamer equipped with
component video inputs.
You will also need a component/P-Scan video cable (not included) with sepa-
rate connectors for Y, Cb/Pb and Cr/Pr signals. This type of cable also supports
the Progressive Scan mode when used with high-end P-Scan TVs. Using the
component video output or P-Scan mode requires the following steps:
1. Preparation:
- First, use an audio/video cable or S-Video cable to connect the DVD play-
er to the composite video or S-Video input on your TV/beamer.
- If you are using model DVD 4010, connect the supplied AC power cord to
the “AC IN” inlet on the rear side of the player, then plug into a power out-
let. As model DVD 4620 has a fixed power cord, only plug the other end of
the fixed power cord into the wall socket, if you are using model DVD 4620.
- Turn on the TV/beamer and the DVD player and select the corresponding
video input on your TV/beamer.
2. Entering the setup menu to change the Video setting:
Enter the player’s setup menu by pressing the “SETUP” button on the
remote control. Use the direction button “
A” to navigate to the “Video
setup page”, then press “ENTER”, navigate down to the “Video output”
menu and press “ENTER” to enter the menu. Use the direction button “
D”
to proceed down to the “YUV” setting and press “ENTER” to confirm your
selection.
3. Connecting the player using the component video cable:
Unplug the composite video or S-Video cable and connect the component
video cable to the appropriate jacks on your TV/Beamer. Normally, cables
and jacks are color-coded to make the connection easier. Then adjust the
TV’s/Beamer’s video input setting to correspond to the component video
input.
AUDIO AND VIDEO CONNECTIONS
COMPONENT VIDEO CABLE
TV or
Beamer
COMPONENT
VIDEO INPUT
4
Note:
This connection is only possible
with model DVD 4620.
AC
B
AC
B
Video setup page
TV shape PS
TV type PAL
Video output S-Vi S-Video
Video mode YUV
P-Scan mode Auto RGB
Video quality
YUV output