Filter
Top Products
2
38
Remote Control Preparation
Other
1. Open the cover.
2. Insert batteries.
Make sure to match the "+" and "-" of the batteries with
the marks inside the battery compartment.
3. Close the cover.
Point the remote control at the remote sensor.
(The pictures are only for reference)
Remarks: Do not expose the remote sensor of the DVD
player to strong light source such as direct sunlight.
Notes:
Point the remote control at the players remote
sensor.
Do not leave the remote control near an extremely
hot or humid place.
Do not spill water or put anything wet on the remote
control.
Battery is -1 year under normal conditions.
Notes:
Improper use of batteries may cause battery leakage and
corrosion. To operate the remote controller correctly, follow
the instruction below.
Do not insert batteries in the wrong direction.
Do not charge, heat, open, or short-circuit the
batteries.
Do not throw batteries into a fire.
Do not leave dead batteries in the Remote Control.
Do not use different types of batteries together or mix
old and new batteries.
If you do not use the remote control for a long
period of time, remove the batteries to avoid
possible damage from battery corrosion.
If the remote control does not function correctly or
the operating range become reduced, replace all
batteries with new ones.
If battery leakage occurs, clean the battery
compartment, then insert new ones.
3
Insert batteries
Using the remote control
1
3