Kodak P460 DVD Player User Manual


 
05
Getting Started
Video Output
Connect the DVD player’s video output (RCA connec-
tor or S-Video) on the rear panel to the TV’s video
input (or other devices) using AV, S-Video or
Component.
Note:
Certain output formats may not be available on all
models. Please check product outer box for available.
Video Connection
Audio Connection
Stereo Configuration
Connect your TV stereo audio inputs (L for left chan-
nel and R for right channel) to the DVD player’s ste-
reo audio output L and R respectively.
Analog 2 Channel Output
For your convenience and cost concern, DVD-Player
supports Dolby 2 Channel audio output directly.
However, you still need to connect the 2 Channel
audio output to your audio amplifier relatively as
following.
Note:
When you connect the DVD player to another device, be sure
to turn off the power and unplug all of the equipment from the
wall outlet before making any connections. The output sound
of the DVD player has a wide dynamic range. Be sure to
adjust the receiver’s volume to a moderate listening level.
Otherwise, the speakers may be damaged by a sudden high
volume sound. Turn off the receiver before you connect or
disconnect the DVD player’s power cord. If you leave the
receiver power on, the speakers may be damaged.
Notes:
1.Refer to the instructions supplied with the component to
be connected.
2.Do not connect this player to a video deck. If you do,
noise may appear in the picture.
V C R
T V
X
Connect
directly
CD / DVD
PLAYER
If your display device supports S-Video terminal,
you can also connect your display device to DVD
player’s S-Video Output connector on the rear
panel.
S-Video Output
YELLOW
Rear of TV set
S-video cord
(not supplied)
S-video input
terminal (S1, S2)
To S-video terminal
White
Red
White Red