Filter
Top Products
KODAK Display Manager System V4.0 User’s Guide 15
Installing and Setting Up Your System
SEQUEL Sensors
Three Sequel sensors are recommended for use with the Display Manager
System.
SEQUEL Chroma 4/C USB Sensor for CRT Monitors
This sensor connects to a USB port and attaches to a CRT monitor with
suction cups.
During calibration, attach the sensor as shown here.
Press the sensor firmly to the screen being careful not to press too hard.
Center it within the patch. Make sure that all suction cups are pressed against
the monitor. If any of the suction cups come loose, the results may be
unreliable and the process should be repeated. If the sensor falls off the
monitor, reattach it and restart the process.
NOTE
You may need to clean the sensor and the screen. See “Sensor Does Not Adhere
to Screen” on page 75.
A
ttach to the
monitor with
s
uction cups
Connect to the
computer USB port